Amprobe INSP-3

• Meter detects faulty wiring in need of repair without removing outlets cover plates, or panel covers: Faulty splices and connections, Incorrect wiring, Undersized wiring, Faulty GFCIs, Faulty or incorrectly wired AFCIs, Incorrect line voltage, Poor ground quality
• Testing efficiency relevant test data (voltage, voltage drop, hot and neutral voltage drop, voltage with load, ground impedance) is presented on a single large display to save operator time no scrolling or switching screens needed
• Verifies if wiring is tested for load carrying ability that it meets electrical code recommendations for voltage drop under load
• User selectable 0, 10,15 and 20 amps loads to verify performance of the electrical system
• Incorrect wiring or voltage drop test failure is clearly indicated by flashing screen
• Will not trip circuit breakers or blow fuses during the test
• Tests GFCI and AFCI operations
• Check ground quality for safety and ability to support sensitive electronic equipment
• Measure fault currents
• Save money and time by eliminating guess work
• NOTE: The Inspector™ III does not check the condition of wiring insulation
• Load: Constant 0, 10, 15 or 20 AMP simulation regardless of line voltage
• Operating Voltage: 95-140 VAC /-2%, /- 2 digits
• GFI Trip: 6.0 mA nominal to trip GFI, 30 mA to trip RCD
• AFCI Trip: Up to 8, 120 AMP pulses within 1/2 second period

>

Each Unit Includes

• Power Cord
• 9V Alkaline Battery (Installed)
• Users Manual
• Carrying Case